| Ctrl+K | Command palette (every command) |
| Alt+N | New model (Ctrl+N is reserved by browsers) |
| Ctrl+O | Open model |
| Ctrl+S | Save now (autosave is on) |
| Ctrl+Shift+S | Save as copy |
| Ctrl+Z | Undo |
| Ctrl+Y, Ctrl+Shift+Z | Redo |
| F5 | Run analysis (every combination with the envelope) |
| Ctrl+P | Print the report |
| F1 | User manual |
| Del, Backspace | Delete the selection (nodes take their members with them) |
| Esc | End the member chain, leave the tool, clear the selection, close a dialog |
| Ctrl+A | Select all |
| N, M, P, S | Node, member, plate, select tool |
| F | Fit the view |
| Z | Zoom to the selection |
| + / − | Zoom |
| L | Load on the selection: nodal load (nodes), distributed load (members), area load (plates) |
| Ctrl+D | Duplicate the selection (Copy with an offset) |
| Ctrl+R | Run the steel design (AISC 360) |
| G, R | Move gizmo, rotate gizmo |
| Tab, Shift+Tab | In the 3D view: select the next / previous node, member or plate |
| Numpad 7, 1, 3, 0 | Top, front, right, iso view; with Ctrl: bottom, back, left. Numpad 5: orthographic; 4 / 6 orbit; 8 / 2 tilt; . zoom to the selection |
| Enter | Finish a triangle plate; confirm a dialog (runs its main button); finish a pick |
| Backspace (pick mode) | Remove the last picked point |
